USC Urban Service Company

RO Water Purifier Guide — Understanding TDS, Filter Life and Basic Maintenance

A 10 min read guide for Bengaluru homes

  • Quality assured
  • Same-day slots
  • From ₹399

11 Nov 2026 · 10 min read · Urban Service Company

Quick answer

What TDS really tells you, which purifier suits which water, how long filters and membranes last, and what to check when your purifier is slow, leaking or tastes wrong. A plain-language guide for homes using borewell, tanker or municipal water.

Last updated:

Skip to related guides

Many homes in Bengaluru rely on a water purifier, and many owners have never been told what it does. Whether you need RO, UV or a simple filter depends on your water source, and how long the filters last depends on how much dirt the water carries. This guide explains TDS, the main purifier types, when filters need changing and the common faults you can check before calling anyone.

What TDS means

TDS stands for total dissolved solids. It is a measure, in milligrams per litre or parts per million, of the minerals, salts and other substances dissolved in water. A handheld TDS meter gives a quick reading.

TDS is not a safety test. It does not detect bacteria, viruses, pesticides or many chemicals. A low reading does not prove water is safe, and a high reading made up of harmless minerals is not necessarily dangerous. TDS mainly tells you about taste and about whether an RO purifier is likely to help.

India's drinking water standard, IS 10500, gives a desirable limit of 500 mg/L for TDS and allows up to 2000 mg/L only where no better source is available. Many people find water above roughly 500 mg/L tastes salty or hard.

Which purifier suits which water

As a general guide, water with low TDS from a well-treated municipal supply often needs only UV or UF purification, which deals with germs and fine particles.

Water with TDS around 500 mg/L or higher, which is common with borewell and some tanker supplies, is where RO helps, because RO removes dissolved salts.

Muddy or cloudy water needs a sediment pre-filter in front of any purifier.

If you are unsure about contamination, get the water tested at a laboratory, because a TDS meter cannot show whether water is microbiologically safe.

Need a repair today in Bengaluru?

Same-day slots. Free diagnosis. Quality assured.

What RO does and its downsides

RO, or reverse osmosis, pushes water through a membrane that removes most dissolved salts. It also removes some useful minerals, and part of the incoming water leaves as reject water. A typical household unit sends several litres of reject water down the drain for each litre of purified water, depending on the model and the incoming TDS.

Very low TDS water, below roughly 50 to 75 mg/L, can taste flat. Some purifiers include a TDS controller or mineraliser that adds minerals back. For young children or people on special diets, follow medical advice on the water they drink.

Reject water is not dirty, only more concentrated. Many households reuse it for mopping, cleaning and watering non-edible plants. It is not for drinking.

How long each part lasts

These are typical ranges. Real life depends on your water quality, how much you use and the model, so follow the manual for your purifier.

Sediment pre-filter: about 3 to 6 months, sooner in muddy water.

Carbon filter: about 6 to 12 months.

RO membrane: often 1.5 to 3 years, depending on the incoming TDS and usage.

UV lamp: about a year of regular use, and many models have an indicator.

Signs it is time to change filters

Water flow slows noticeably, or the tank takes much longer to fill.

The taste or smell of the water changes.

The TDS of purified water rises close to the TDS of the input water, which suggests the membrane is no longer rejecting salts well.

The purifier's alert light, beep or voice message tells you a filter or UV lamp is due.

You can estimate the membrane's rejection rate by subtracting the purified TDS from the input TDS and dividing by the input TDS. A healthy membrane usually removes well over 80 percent. A rate that has dropped below that is a sign the membrane is tiring.

Maintenance you can do yourself

Replace filters on schedule, not after they fail.

Use genuine or manufacturer-approved cartridges, because poorly fitting or low-quality filters can leak or not filter properly.

Clean the outside of the purifier and the tap with a damp cloth.

Clean or sanitise the storage tank as the manual describes, because stored water can go stale.

If the purifier has been off for several days, run some water out before drinking.

Check the inlet hose and fittings for leaks and kinks.

Common problems you can check first

No water or very slow flow: check that the inlet tap is open, that the supply pressure is adequate, that the sediment filter is not clogged and that the power adapter light is on.

The purifier runs but the tank does not fill: look for kinked tubes or a clogged membrane. A weak pump also causes this and needs a technician.

Water tastes bad: change the carbon filter, flush the storage tank and check the TDS.

A leak or constant dripping: check that the tubing connections and cartridges are fitted correctly. A leaking fitting should be repaired promptly.

Beeping or an indicator light: this is often a filter-change or UV alert. Check the manual for the meaning.

No power light: check the socket and the adapter.

Pump, solenoid valve, power board and membrane replacement are technician jobs. Switch the purifier off and close the inlet tap before opening any housing.

FAQs — water purifiers and TDS

What TDS level is safe for drinking?

India's standard IS 10500 lists 500 mg/L as the desirable limit and 2000 mg/L as the maximum where no better source exists. TDS alone does not show whether water is free from germs or chemicals.

Do I need RO if my water has low TDS?

Often not. If TDS is low, a UV or UF purifier may be enough. Get a water test if you are unsure about contamination.

How often should I change RO filters?

Pre-filters about every 3 to 6 months, the carbon filter every 6 to 12 months and the membrane every 1.5 to 3 years. Follow your model's manual and adjust for your water quality.

Can I reuse the reject water from an RO purifier?

Yes, for cleaning, mopping and watering non-edible plants. It is not for drinking.

Why is my RO water so slow?

A clogged sediment filter, low inlet pressure, a tired membrane or a weak pump are the common causes. Replace any overdue filters first.

Final takeaway

Know your water's TDS, pick the purifier type that matches it, replace filters on schedule and keep an eye on flow and taste. Most purifier trouble comes from filters left in place too long.

Common water filter problems — quick guides

Symptom-by-symptom guides for water filter repair in Bengaluru.