USC Urban Service Company

How to Clean a Washing Machine and Remove Bad Smells — Step-by-Step Guide

A 9 min read guide for Bengaluru homes

  • Quality assured
  • Same-day slots
  • From ₹399

11 Nov 2026 · 9 min read · Urban Service Company

Quick answer

A musty smell, black spots on the rubber door seal or clothes that come out smelling worse than they went in all point to a dirty machine. Here is how to deep-clean a front-load or top-load washing machine at home, what to avoid, and when a smell means something is actually broken.

Last updated:

Skip to related guides

A washing machine spends its life wet, warm and full of soap, which is exactly the environment where mould and bacteria grow. If your clothes come out smelling musty, if there are black or pink spots on the rubber door seal, or if the drum itself smells when you open it, the machine needs cleaning, not a repair. In most homes this takes about an hour and costs very little.

This guide covers front-load and top-load machines. The methods differ slightly, so check your user manual for any cleaning programme or product your manufacturer specifically recommends, and follow that where it differs from the general steps below.

Always switch the machine off at the socket before cleaning any part you reach by hand, and keep water away from the control panel.

Why washing machines start to smell

Smells come from three things: damp, detergent residue and trapped dirt. After a wash, water stays in the rubber seal of a front-loader, in the detergent drawer and in the drain hose. Warm, moist, dark places let mould grow within days.

Using too much detergent makes it worse. Detergent that does not rinse out leaves a film on the drum and hoses that feeds bacteria. Washing mostly in cold water, which many households do to save electricity, also leaves more residue than occasional hot washes.

In Bengaluru, humidity during the monsoon adds to the problem, and in areas where borewell or tanker water is used, hard water leaves limescale on the drum and heating element. Scale traps dirt and moisture, so a machine in a hard-water home usually needs cleaning more often.

What you need

A soft cloth and an old toothbrush for the rubber seal and the detergent drawer.

A washing machine cleaner or descaler made for your type of machine, or the cleaning tablet your manufacturer recommends.

A shallow tray and a towel for the drain filter, which holds some water.

Mild dish soap and warm water.

Need a repair today in Bengaluru?

Same-day slots. Free diagnosis. Quality assured.

Step 1: Clean the rubber door seal (front-load machines)

Pull back the rubber gasket and look inside the folds. This is where black mould collects, along with hair, lint and sometimes coins or small objects that fell out of pockets.

Wipe the folds with a cloth dipped in warm water and a little dish soap, and use the toothbrush on stubborn spots. Dry the gasket with a dry cloth afterwards. Some people use diluted white vinegar on mould spots, but wipe it off well and do not leave it sitting on the rubber, because acids can dry out a seal over time.

Leave the door open once it is dry.

Step 2: Clean the detergent drawer

Pull the drawer out fully. Most drawers release with a small catch or by pressing a tab, and your manual shows the method for your model.

Soak the drawer in warm soapy water, scrub off the residue, rinse it and dry it. Wipe the cavity the drawer sits in as well, because residue builds up there too.

Step 3: Clean the drain pump filter

Front-load machines have a small access panel at the bottom front. Behind it is a filter that catches lint, coins, hairpins and buttons. A blocked filter causes bad smells, slow draining and error codes.

Put a shallow tray and a towel under the panel, because a cup or more of water will come out. Unscrew the filter slowly, let the water drain, remove the debris, rinse the filter and screw it back in fully so it does not leak.

Top-load machines usually have a lint filter or mesh bag on the agitator or along the tub wall. Empty and rinse it every few weeks.

Step 4: Run a deep-clean cycle

Many machines have a tub clean or drum clean programme. Use it with the cleaner or tablet recommended for your model. If your machine has no such programme, run the hottest long cycle with the drum empty and the recommended cleaner.

Do not mix cleaning products. In particular, never mix bleach with vinegar or with other cleaners, because the combination can release a toxic gas.

When the cycle ends, wipe the drum, the glass door and the seal, then leave the door open so everything dries.

Step 5: Check the inlet filter and hoses

The water inlet hose has a small mesh filter where it connects to the machine. If the machine fills slowly or shows a water-supply error, close the tap, remove the hose at the machine end and rinse the mesh.

Look at the drain hose too. It should rise in a smooth curve and not be kinked or squashed behind the machine. A kinked or very low hose can hold standing water that smells.

Keeping the smell away

Leave the door or lid open after every wash so the drum can dry.

Wipe the door seal after the last wash of the day.

Use the amount of detergent printed on the pack for your load size and water hardness. More soap does not clean better.

Use a detergent made for your machine type. Front-load and fully automatic machines need low-foam detergent.

Do not leave wet clothes sitting in the drum for hours.

Run a hot wash or tub-clean cycle about once a month.

Do not overload the drum, because packed clothes do not rinse properly.

When a smell means something is broken

If the smell stays after a thorough clean, look for a cause that cleaning cannot fix. A partly blocked drain hose or standpipe, a drain pump that is not emptying the drum fully, or a leak that leaves water sitting under the machine can all cause persistent smells.

A burning smell, a smell of hot plastic or any smoke is not a cleaning problem. Stop the machine, switch it off at the socket and have it checked. The same applies to water on the floor, a drum that does not spin, or error codes that return after you clear the filter.

FAQs — cleaning a washing machine

How often should I clean my washing machine?

Run a hot or tub-clean cycle about once a month, wipe the door seal and detergent drawer every week or two, and clean the drain pump filter every two to three months. Heavy use or hard water means cleaning a little more often.

Is vinegar safe to use in a washing machine?

Many people use diluted vinegar for light cleaning, but some manufacturers advise against regular use because acids can wear rubber seals and hoses over time. Check your manual and prefer the cleaner it recommends for deep cleaning.

Why do my clothes smell even after washing?

The usual causes are mould in the seal or drum, too much detergent, or leaving wet clothes in the drum. Clean the machine, reduce the detergent and take clothes out promptly.

Can I clean the drum with bleach?

Only if your manual allows it, and never mix bleach with vinegar or other cleaners. A cleaner made for washing machines is the safer choice.

Why does my front-load washer have black spots on the door seal?

Black spots are mould growing on trapped moisture. Wipe the seal after washing, leave the door open and clean the folds with soapy water.

Final takeaway

Most washing machine smells come from moisture and detergent residue, and a monthly clean plus a few habit changes fixes them. If smells, leaks or error codes continue after a thorough clean, the machine may have a drain or pump fault that is worth having looked at.